bike, cleats, dirt bike, enduro, endurocross, flo motorsports, flomotorsports, foot pegs, footpegs, harley, honda, husqvarna, kawasaki, ktm, maintenance, moto, motocross, race, riders, supercross, suzuki, yamaha - December 14, 2016

Flo Motorsports Radiator Guard Installation

Flo Motorsports KTM / Husqvarna Radiator Guards / Brace Installation

Installation of the Flo radiator brace/guard is very simple and can be done in about 20 minutes. All that is required is to pull the seat and radiator shrouds, we found it a bit easier just to pull the tank with shrouds attached. The stock factory plastic radiator protectors pop out of their retaining mounts, remove both then remove the short, #30 Torx bolts attaching the radiators to the frame. The Flow guards mount to the radiators/frame mounts with longer 10mm head bolts (supplied) and the short bolts removed previously are used to fasten the outer Flo guard to the radiator. Blue Loctite is recommended to keep hardware in place. Re-install the tank/seat and you’re good to go!